Advertisement
How to disassemble and assemble
3-10 DISPENSER
1. Remove the display pulling out with tools such as Flat-tip
screwdriver on one side and repeat the process on the other side
while pulling it forward as shown in the picture.
2. Loosen four screws with a phillips screwdriver and pull the
funnel assembly to disconnect.
Funnel Assembly
3. The duct cap assembly can be disconnected if the hold
lever connecting screws are loosened with a phillips driver.
Motor Assembly
Holder
Lever
Assembly
Duct Cap
4. To install the duct cap assembly, insert one end of the spring
into the right hole of the dispenser lever and insert the other
end into the right hole in the top part of the dispenser. Then
attach the holder at the solenoid switch.
3-11 DISPLAY PCB
As shown below, remove 1 screw on the PCB fixing screw.
Remove the display PCB fixing screw.
Case, PCB
Case, PCB
Funnel
3-12 ICE BUTTON ASSEMBLY
1) Remove the 1 screw holding the lever.
2) Remove the spring from the hook.
3) Push and pull on the tab to remove.
Button Lever
3-13 WATER BUTTON ASSMEBLY
1) Remove screws.
2) Grasp the Button assembly and lift.
Button Lever
Motor Assembly
Display PCB
Display PCB
Figure 28
Advertisement
