Advertisement
Micom Function
Models: LSXS26336*
1-1. Display Function
When the Appliance is plugged in, it is set to step 4 for refrigerator and freezer. You can adjust the Refrigerator and the
Freezer control temperature by pressing the Freezer and Refrigerator Button.
When the power initially applied or restored after a power failure, it is set to the previously controlled temperature.
1-2. Demonstration Mode (OFF Mode)
1 Any Door must be opened to enter in this mode
）
2 To activate this mode press and hold ULTRA ICE and REFRIGERATOR TEMP button over 5 seconds
）
3 The display will show the word
）
4 In this mode all loads are turned off Compressor Heater Fans etc
）
5 Lamps and Dispenser Functions works normally even in demonstration mode the refrigerator Lamp automatic off function
）
works normally
）
6 To exit Demonstration mode open any Door then press and hold
）
seconds Display return to normal mode
（
1-3
Key Lock Button (dispenser and display lock)
1) When the refrigerator is first turned on, the buttons are not locked. The display panel shows the padlock unlocked icon.
2) To lock the display, the dispenser, and the control panel, press, and hold the ALARM/LOCK button for 3 seconds. The
locked pad lock icon is displayed.
3) The ALARM/LOCK button is the only control feature that remains active in the locked state. The buzzer sound, other
control buttons, and the dispenser are deactivated.
4) To release from the locked state, press and hold the ALARM/LOCK button again for 3 seconds.
1-4. Filter cartridge status reset button
1) There is a replacement indicator for filter cartridge on the dispenser.
2) Water filter needs replacement once six months.
3) Initial filter icon condition is OFF.
4) After six months of use, change filter icon LED will be turned ON.
5) Once filter cartridge has been replaced, press and hold
6) Icon LED will be turned OFF by a 6 months period.
Ice Plus
"
OFF".
（
，
（
）
．
Ex) "LOCK"
Function OFF
Water Filter
In initial Power On /
．
，
，
）
and REFRIGERATOR TEMP button over 5
Ice Plus
Ex) "LOCK"
Function ON
button for more than 3 seconds.
Filter Reset
．
Replace indicator
light on
Advertisement
