Table of Contents
Advertisement
Securing the Trailer to the
Tow Vehicle
1.
Lift up the tongue handle
Note:
Lifting the handle retracts the slide
assembly.
Figure 26
1. Tongue handle
2. Tongue pin
2.
Align the tongue pin with the tow-vehicle hitch
(Figure
27).
Figure 27
1. Tongue pin
3.
Release the tongue handle
the trailer to the tow-vehicle hitch.
Ensure that the slide assembly is centered
below the tongue pin.
(Figure
26).
g337017
3. Slide assembly
g338301
2. Tow-vehicle hitch
(Figure
27) to secure
Loading the Trailer
Preparing the Load the Trailer
1.
Chock the trailer wheels.
2.
Pull the latch pins on both sides of the trailer to
release the rails or ramps and lower them to the
ground
(Figure
Rail Kit equipped
1. Latch pin (right side shown)
3.
Remove the grass baskets from the greens
mower.
Note:
You can store the grass baskets in the
tow vehicle.
4.
Refer to the appropriate instruction for an
equipped ramp or rail kit as follows:
•
Rail Kit: Install the rail wheels onto the hex
shafts
(Figure
Note:
The rail-wheel clip slots are facing
outwards for all walk-behind Greensmaster
machines.
12
28).
Figure 28
29).
g338736
Advertisement
Table of Contents
