Table of Contents
Advertisement
Checking the Torque of the
Wheel Lug Nuts
Service Interval: After the first 10 hours
Torque specification: 108 N⋅m (80 ft-lb)
Check the torque of the wheel lug nuts each time
you install the wheels and after the first 10 hours of
operation.
Torque the wheel lug nuts in the pattern as shown in
Figure 34
to the specified torque.
WARNING
Failure to maintain proper torque could result
in failure or loss of wheel and could result in
personal injury.
Torque the wheel lug nuts to the specified
torque.
Figure 34
Checking the Stop Gap
Rail-Loading Kit Only
Service Interval: Yearly
With the ramps secured in the raised position, check
the gap measurement between the stop and bottom
of the rail.
The appropriate measurement should be 2.5 mm (0.1
inch) as shown in
measurement, adjust the turnbuckle and jam nut until
you reach the appropriate measurement.
g274650
1. Rail
2. Gap—2.5 mm (0.1 inch)
16
Figure
35. If you observe a different
Figure 35
3. Stop
g348160
Advertisement
Table of Contents
