Advertisement
5. How to Use (continued)
When using PZ-43SMF-E
Also read the Instruction Book for the remote controller (PZ-43SMF-E).
This cannot be used together with the remote controller (PZ-61DR-E).
System example
Lossnay
Power supply
■ Component Names
A Ventilation mode
Displayed the ventilation mode status.
Heat exchange
By-pass
Automatic (HEAT EX./BY-PASS)
* The mode appears only when the optional motorized
damper (P-133DUE-E) is used.
B Power Display
Displayed while the Lossnay remote controller is powered
on.
C [TIMER] Display
Displayed on-timer or off-timer duration.
D [NOT AVAILABLE] Display
When a button is pressed for a function which the Lossnay
unit cannot perform, this display flashes concurrently with
the display of the function.
E Fan speed Display
Displayed the selected fan speed.
F [CHECK] Display
Displayed together with the malfunctioning unit (3 digits)
and an error code (4 digits).
G [FILTER] Display
Displayed when the accumulated operating time reaches at
the time set for filter maintenance.
Operate the product by the
remote controller.
Remote controller
(System components)
A
B
C
D
H
I
or
Operation
E
F
G
J
K
L
M
H [Ventilation mode] Button
Used to select the ventilation mode among heat exchange,
by-pass or automatic.
* The mode can be switched only when the optional
motorized damper (P-133DUE-E) is used.
I [TIMER] Button
Increasing 0:30 by pressing it once.
Keep pressing the button for fast-forwarding.
J [ON/OFF] Button
Switch for start and stop.
K Operation lamp
On during operation. Flashes when a malfunction occurs.
L [Fan Speed] Button
Used to select the fan speed either "Low" or "High".
Low
High
Note: If this button is pressed when trying to switch the fan
speed of a Lossnay unit which is not equipped with the
fan speed adjustment, the fan speed display and NOT
AVAILABLE display flash and the unit's fan speed does
not change.
M [FILTER] Button
Press twice to reset the filter sign display.
Note:
- When power is restored after an outage or when the
corresponding circuit breaker on the power board is reset, all
models will return to the condition before the supply of power
was interrupted.
- When the backlight is off, pressing any button turns the backlight
on and does not perform its function. (except "ON/OFF" button)
Eng-11
Advertisement
