Installing The Canopy Housing; Assembling The Fan Blades - Fanimation The Caruso FP7000 Series Owner's Manual

NOTE: This step is applicable after the necessary wiring
is completed. (see pages 8 and 9)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Screw in two threaded rods into the Hanger Bracket
(Figure 1a).
NOTE: The threaded rods in the hanger bracket serves as
guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 1b)
INSTALLATION NOTE
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled may
result in damage to the fan blades.
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
1. Remove and discard the (rubber) motor "stops" by
removing the five screws. (Figure 1)
Blade & Blade Holder Assembly:
2. Lay the side of the blade holder on a flat surface with the
inside of the blade holder facing up.
3. Assemble the blade to the blade holder with the carriage
nuts, washer-head screws & fiber washers and the blade
cover. Make sure the bottom edge of the blade is fully
seated against the blade holder.
4. Tighten screws with a screwdriver provided, don't over-
tighten. (Figure 2)
5. Attach assembled blades and blade holders to the motor
hub using the provided screws & lock washers. (Figure 3)
6. Make sure the screws securing the blade holders to the
motor hub are tight and that the blade holders are properly
seated.

Installing the Canopy Housing

Assembling the Fan Blades

NOTE: Supply wires and fan wires omitted for clarity
Figure 1a
Fan Blade
▲WARNING
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in between
the rotating blades.
10
Figure 1b
Figure 1
Blade
Cover
Figure 2
Blade
Holder