Safety Instructions - GALAXIS SHOWTECHNIK PYROTEC PFE Advanced Mini 5 Outputs User Manual

6

1.3 Safety Instructions

Safety instructions for the firing of pyrotechnical effects and aerial
shells by using e-matches:
The following instructions are for your understanding about important and
basic safety principles.
Our general safety requirements are based on our own experience plus the
contact and feedback from our customers. These rules allow the safe and
successful usage of all components of our wireless firing systems. With
proceeding development of our products, we will continuously revise and
adapt the safety standards in conclusion with your notifications and
support.
The following safety instructions are part of all our operation manuals
within our product range. These instructions are also available in printed
form and can be downloaded via our internet homepage at any time. Please
forward these instructions to any relevant persons in your company dealing
with this topic.
Any technical device can potentially cause a fault. This could be
encouraged through: wrong usage, unit damage, unit aging as well as the
wear and tear of the unit. This fundamental thesis was the basic principle
when writing these instructions.
1. Smoking or open fire is strictly prohibited within the safety zone!
2. Depending on the type, size and quantity of the pyrotechnical effects
that are being used and depending on the local conditions, allocate the
necessary fire prevention and first aid measurements.
3. In all cases respect and follow any national and technical regulations
as well as the operation manuals respective to the pyrotechnical effects in
use.
4. Make sure that non authorized persons are not within the vicinity of the
pyrotechnical effects and to the respective firing system.
5. The safety boundary distances required by the manufacturer and
authorities are to be respected. Secure the area so that non authorized
persons cannot gain access to the same.
6. The operation manuals and safety instructions of the pyrotechnical
manufacturers must be observed at all times. If in doubt these must be
discussed with the relevant safety organisations.
7. The usage of pyrotechnical effects as well as the respective firing
systems are only allowed to be used according to it's defined function.
8. The components of our firing system are to be covered or encased against
burn-off cinders or weather conditions where necessary. Electrical contacts
should be protected against corrosion, soiling and damage plus they should
be cleaned regularly.
9. The contacts of the pyrotechnical articles or their e-matches, which
have not yet been connected, must always be short circuited.
10. We recommend to have our products inspected every one to two years.
Along with the testing of the rechargeable battery, a visual test as well
as a functional test will prove that the operational safety standards are
still met.