Radio Range Test; Remote Access - GALAXIS SHOWTECHNIK PYROTEC PFE Advanced Mini 5 Outputs User Manual

8.1 Radio Range Test

The remote access functions of the controller PFC Advanced make very convenient radio range tests
possible because the signal strength of both devices (signal back and forth) are displayed at the
controller.
If you want to read the test result at the receiver or if you work with the transmitter PFS Profi or PFS
Pocket the radio range test can also be done the conventional way.
After starting the test procedure, the receivers will for example display the following text:
TIP

9 Remote access

If the device has been accessed remotely one of the following text messages will be displayed
depending whether data is being read from the device or data is being written to the memory of the
receiver:
This result means that the distance to the transmitter can be approximately
doubled until the signal will be too low. In general, you should try to achieve
at least a signal level of 30%.
An 'OK-PRG-Test' is executed automatically during a range test if the
device is in the operation mode '10 Outputs'. First the multicolor LEDs
display the result of the continuity check for 5 seconds followed by the
status of the output programming for another 5 seconds.
The device is transmitting while the controller is receiving data.
The controller is transmitting data which is written to the receiver's memory.
33