Table of Contents
Advertisement
Quick Links
Operation & Maintenance Manual
Lync AquaSolve
Anti-Scale Systems
Chemical-Free, Salt-Free
Scale Prevention
LM8408-COM (12 GPM)
LM8410-COM (20 GPM)
Important: Read this Manual BEFORE using this equipment. Failure
to read and follow all safety and use information can result in death,
serious personal injury, property damage, or damage to the
equipment. Keep this Manual for future reference.
OMM-LM8408_LM8410-COM_EN
Lync • 425 W Everman Pkway, St. 101
Technical Support • (800) 433-5654 (ext. 3) • Mon-Fri, 8 am - 5 pm CST
Engineered Solutions
|
Fort Worth, TX 76134
|
(817) 335-9531
© 2021 Lync
Advertisement
Table of Contents
Related Manuals for Watts Lync AquaSolve LM8408-COM
Summary of Contents for Watts Lync AquaSolve LM8408-COM
- Page 1 Operation & Maintenance Manual Lync AquaSolve Anti-Scale Systems Chemical-Free, Salt-Free Scale Prevention LM8408-COM (12 GPM) LM8410-COM (20 GPM) Important: Read this Manual BEFORE using this equipment. Failure to read and follow all safety and use information can result in death, serious personal injury, property damage, or damage to the equipment.
- Page 2 Operation & Maintenance Manual Lync AquaSolve INTRODUCTION • Compatible with all on-site and community wastewater treatment systems The AquaSolve provides protection from scale for- • Perfect system for towns or communities where mation on internal plumbing surfaces. The AquaSolve water softeners are banned or restricted can be installed at the point of entry to a building to •...
-
Page 3: Specifications
Operation & Maintenance Manual Lync AquaSolve Specifications NOTICE Spotting May Occur on External Plumbing Surfaces. AquaSolve shall be installed on the main water ser- AquaSolve media systems perform best in single pass pota- vice pipe just after it enters the building, but after ble water applications with NO additional chemical additives. -
Page 4: Equipment Specifications
Equipment Specifications *****All other contaminants must meet the requirements of the USEPA Safe Drinking Water Act. Specific Mineral and Metal MCL’s, identified in Watts published Feed Water Chemistry Requirements, supersedes the AquaSolve systems are complete, selfcontained, USEPA SDWA. loaded with media, and ready to use. A simple... -
Page 5: Installation
Operation & Maintenance Manual Lync AquaSolve NOTICE Replacement Media • We recommend the installation of a dual-union ball-valve on Model Part # Frequency the inlet and outlet to isolate the tank for servicing. Media should be replaced • A full bypass should be installed so that the full service flow LM8408-COM-RM 114903 every 3 years... -
Page 6: Bypass Valve
Operation & Maintenance Manual Lync AquaSolve By-Pass Valve AquaSolve Treated Water AquaSolve Untreated Water Installation and Start-Up 4. Connect the cold water supply to the inlet of the Lync AquaSolve system. Install an inlet water sup- ply valve (user supplied) in this line and close it. NOTE: The AquaSolve system operates in the UP-FLOW mode which is opposite of a conventional softener. -
Page 7: Replacing The Media
Operation & Maintenance Manual Lync AquaSolve 11. When all the old media is removed turn off the NOTICE garden hose and continue to siphon until the tank is Your AquaSolve media should be replaced every 3 years. Dispose about half full with water. of old media and/or container in accordance with local, regional, national, and/or international regulations. -
Page 8: Limited Warranty
Installation and Operation Manual. vandalism, negligence, fouling caused by foreign material, damage from adverse water conditions, chemical, or any other circumstances over which Watts Regulator Company has no control. This warranty shall be Conditions invalidated by any abuse, misuse, misapplication or improper installation •...