lens and the LCD block.
8.17. Removal of Analysis Block
1. Remove the upper case according to the section 8.2. "Removal of
Upper Case".
2. Remove the A-P.C.Board according to the section 8.4. "Removal of
A-P.C.Board".
3. Disconnect the connector between the speaker (L) and G-
P.C.Board.
4. Loosen the lamp unit fixing screws (2 × 2) until they turn freely,
then hold the handle and pull the lamp units 1 and 2 out to remove.
Caution:
- Pay attention to handle lamp units (see 1.3.).
5. Unscrew the screws (2 × 2) and remove the lamp unit terminals.
6. Unscrew the 2 screws and remove the bimetal.
30