Panasonic PT-L6500U Service Manual page 16

7.2. Setting the Remote Control Unit ID
When controlling multiple projectors simultaneously with a single remote control unit, remote
control unit ID is set into the projector ID or into "ALL" as described in the steps below:
1. Push ID SET button on the remote control unit.
ID number "ALL" will be displayed on the OSD.
2. Press the ID SET button 2 seconds or longer.
The ID number will change into "1". The ID SET button will now
toggle through ID numbers "2", "3", "ALL", "1", and so on each
time it is subsequently pushed.
3. Select the ID number you wish, then push ENTER button on the
remote control unit.
Note:
Since the remote control unit ID is set to "ALL" by initial setting, it
is not required to set an ID number when the initial setting is not
changed.
8. Disassembly Instructions
Warning:
Be sure to unplug the power cord from the power outlet before
disassembling this projector.
Caution:
- While turning over a printed circuit board, be sure to put a
insulating material under it to prevent a short circuit.
- Printed circuit boards and wires must not be pulled forcibly, but be
16