Adding And Removing Sodimms; Adding A Sodimm - Extreme Networks Alpine 3800 FM-24MFi Hardware Installation Manual

A
DDING AND
To add a SODIMM to the SMMi, follow these steps:
1 Prior to removing or installing SODIMMs on the SMMi, put on the ESD wrist strap
that is provided with the chassis, and connect the metal end to the ground receptacle
located on the top-right corner of the Alpine 3800 switch front panel.
2 Locate the SODIMM sockets on the SMMi.
3 Position the SODIMM in the socket by ensuring that the gold fingers of the
SODIMM slip into the connector and the keying notches align.
4 Secure the SODIMM by pressing down firmly until the SODIMM is locked into the
socket and the ejector locks rotate into position, as shown in
Figure 3-7: Adding a SODIMM
To remove a SODIMM, follow these steps:
1 Prior to removing or installing SODIMMs on the SMMi, put on the ESD wrist strap
that is provided with the chassis, and connect the metal end to the ground receptacle
located on the top-right corner of the Alpine 3800 switch front panel.
2 Disengage the SODIMM by pulling out on the ejector locks located on either side of
the SODIMM.
3 Rotate the SODIMM out of the socket.
A 3800 S S H
LPINE ERIES WITCH ARDWARE
R SODIMM
EMOVING
I G
NSTALLATION UIDE
A
DDING AND
S
Figure 3-7.
R SODIMM
EMOVING S
38_SODM
3-11