Extreme Networks Alpine 3800 FM-24MFi Hardware Installation Manual page 42

I S
NSTALLATION AND ETUP
To install the SMMi follow these steps:
1 Ensure that the SMMi is right side up (printed circuit board, or PCB, on top) and the
ejector/injector handles are extended, as shown in
Figure 2-5: SMMi with extended ejector/injector handles
2 Slide the SMMi into the appropriate slot of the chassis, until it is fully seated in the
backplane.
Use the metal front panel, not the PCB, to guide the SMMi into the chassis.
When the SMMi is fully seated in the chassis, the ejector/injector handles will begin
to close.
Caution: The SMMi can be installed in the top slot only. The SMMi does not fit in
any other chassis slots.
3 To secure the SMMi in the chassis, close the ejector/injector handles by pushing on
them toward the center of the module card, and tighten the screws using a
#2 Phillips-head screwdriver.
To install the I/O module(s), follow these steps:
1 Ensure that the I/O module is right side up, and the ejector/injector levers are
extended.
2 Slide the I/O module into the appropriate slot of the chassis, until it is fully seated
in the backplane.
Caution: The I/O module can only be installed in the slots labeled Slot 1 through
Slot 4 on the Alpine 3804, or Slot 1 through Slot 8 on the Alpine 3808. Forceful
insertion can damage the I/O module.
When the I/O module is fully seated in the chassis, the ejector/injector levers will
begin to close.
2-8
Figure 2-5.
A 3800 S S
LPINE ERIES WITCH
38_clips
H I G
ARDWARE NSTALLATION UIDE