Advertisement
(0.065") in diameter maximum 12m
long (you may find it easier to
practice with a shorter line length at
first). Find the center of the line and
loop it onto the notch in the center
flange of the spool. Wind the line
around the spool, in the direction
indicated by the arrow on the spool,
keeping each end of the line in its
own channel. Keep the line tight as
you wind so that the line coils
smoothly onto the spool
Wrap the line around the spool
leaving about 20cm line exposed on
each side
Keep the line tight and clip the lines
into the notches in the bottom
flange of the spool to hold the line
in place while you fit the spool into
the housing.
The smaller end of the spring goes
into the top of the spool
Then put the spool and spring into
the housing leaving the ends of the
line protruding from the cutouts on
each side.
Thread the string guides onto the
line as shown
Slide into place. Do the same on
both sides.
Position the cover in place as shown
and press the cover onto the
housing until the clips snap into
place.
Pull-on both ends of the line to free
them from the notches in the spool.
To replace the spool, press on the
spool lock button and screw the
head clockwise onto the shaft and
hand tighten.
10 / 20
Advertisement
