Advertisement
Fitting the plant guard
The plant guard is used to prevent
your trimmer from cutting your
plants. The wire plant guard is
inserted into the holes provided in
the front of the head. The plant
guard can be folded up when not in
use, or easily removed
Fitting and Removal of the
battery
The battery should always be
removed whenever you are not
using the tool and especially when
you are adjusting or transporting
the tool to avoid accidental
operation.
To insert the battery, slide it into
the battery cradle on the top of the
line trimmer, aligning the ribs in the
cradle with the slots in the battery
until it latches into place. Check that
the battery is securely locked into
place
To remove the battery press and
hold the latch on the rear of the
battery pack and slide the battery
away from the trimmer.
Rewinding the spool
The spool is supplied with the line
pre-wound. The twisted line is
1.65mm (0.065") in diameter, which
gives a good cutting performance
and reduced noise. Follow the
instructions below to rewind a new
line onto the spool.
To remove the string head, press
and hold the shaft lock button and
unscrew the head anti-clockwise.
Component parts of the string head
Cut a piece of nylon line 1.65mm
9 / 20
Advertisement
