Advertisement
Assembly - Hanging the Fan (continued)
7
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws
(GG) in the mounting bracket (A). Push up to engage the slots
and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (GG).
□
Align the oval shape on the canopy (C) with canopy bottom
cover (HH), Push up the canopy bottom cover (HH) until the
screw (GG) heads engage to the slots on the canopy bottom
cover (HH) so that the magnetic canopy bottom cover (HH) can
be attached to the bottom of the canopy (C) properly.
8
Installing the blades
□
Attach a blade (F) to the fan motor assembly (E) by inserting
the blade (F) into slots in the side of the fan motor assembly (E)
and aligning the three screw holes in the blade with the holes
in the center flywheel and secure with screws (FF).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
GG
E
F
11
Please contact 1-855-HD-HAMPTON for further assistance.
A
C
HH
D
E
FF
HAMPTONBAY.COM
Advertisement
