Huawei NetEngine-8000-M8 Manual page 11

Installing Boards and Components
1
Installing Boards
Filler panels must be installed in vacant slots to ensure good electromagnetic compatibility and meet dustproof and heat
dissipation requirements. The filler panel in a slot can be removed only before you insert an interface board into the slot.
Removing multiple filler panels and then inserting multiple interface boards at the same time is not allowed.
• Loosen the screws on a filler panel, and
remove the filler panel.
• Hold the ejector levers on the front panel
of a board and raise them to form an angle
of approximately 45 degrees with the front
panel. Then, push the board gently along
the guide rail until the board cannot go any
further.
• Press the two ejector levers inwards until
they cannot move further (Ensure that the
self-locking latch of the ejector lever is
locked into the panel when installing the
system control board).
• Tighten the screws on the panel then
install the other board.
Before installing a board, put on an ESD wrist strap
or ESD gloves and ensure that the slot is correct. If
it is difficult to insert a board, stop the operation.
11