Community Playthings Community Loft 1 Starter Product Manual page 8

5
Check the joints. Every panel should be
locked in place by four connector rings.
Repeat this step for each panel as you
build your loft.
7
Slide another connector ring flat side
down onto each post.
6
6
To add the next panel, lift one of the con-
nector rings and use it to capture the new
panel. Assemble your loft by following the
configuration (see page 10-11). Go slowly;
it is not easy to replace a panel after a
layer is placed on top.
8
Lay platforms in place. Add the stairs. All
four corners of each stair should fit into
connector rings.
The Community Loft