Impex MARCY MWM-8900 Owner's Manual page 10

STEP 3 (See Diagram 3)
A.) Slide fourteen Weight Plates (#54) onto the rear set of Guide Rods (#4). Make sure the
groove on the plates all face toward the front of the machine.
B.) Insert a Selector Rod (#53) into the center holes. Slide a Selector Stem (#34) onto the
two Guide Rods. Slide a Ø 1 ¾" Rubber Bumper (#34) onto the Selector Rod.
C.) Repeat procedures A & B above to install the other fourteen Weight Plates onto the front
two Guide Rods. Make sure the grooves face the back of the machine.
9
DIAGRAM 3