Minolta EP3010 Manual page 223

Enlargement
1. After the leading edge registration for the Book
Second Page has been adjusted, make two single
copies in an enlargement mode (× 2.000) and
check for leading edge registration on the second
copy.
1139D037AB
2. Press the User Mode key, Meter Count key, Stop
key, 10-keys "0", 10-keys "0", Stop key, 10-keys "0",
and 10-keys "1", in that order, on the control panel
to set the copier into the Tech. Rep. mode.
3. Press the Stop key and then the Start key to set
the copier into the Factory Setting mode.
1149D086CA
4. Touch "Adjust" to open the "Adjust 1/2" menu, then
touch "Next" to access the "Adjust 2/2" menu.
5. Touch " " to highlight "A11 Scan Regist Enlarge-
ment."
1173D022CA
6. Using the " " or " " key, change the value so that
width A falls within the specified range.
NOTE
If width A on the copy is smaller than 37.0, touch the
" " key.
If width A on the copy is greater than 43.0, touch the
" " key.
1173D022CA
7. Press the Start key.
(Check the image again. If the image does not
meet the Specifications, readjust.)
D-61