Minolta EP3010 Manual page 187

4. Hook the length of cable on the left (looking at the
copier from the rear), around Pulleys C and B and
secure it to the frame.
1149D041AB
5. Peeling off the tape, pull the length of cable on the
right (looking at the copier from the rear) and hook
it onto Pulleys A and B.
1149D042AA
NOTE
• Hook the length of cable on the left (looking at the
copier from the rear) onto the lower groove in Pulley
B. (Fit the round terminal as illustrated on the left.)
• Hook the length of cable on the right (looking at the
copier from the rear) onto the upper groove in Pulley
B.
1149D043AA
6. Fit the cable into the groove in the cable guide and
hook the spring.
7. Mount Master Board (four screws).
1139D142AA
8. Fit the ADF fixing bracket (one screw).
9. Mount Optical Section Cooling Fan Motor (two
screws).
1149D044AA
D-25