ATD Tools ATD5217 Owner's Manual

ATD Tools ATD5217 Owner's Manual

Air operated chassis pump

Advertisement

Quick Links

ATD5217
FOR 120 LB. DRUMS
MADE IN MEXICO
AIR OPERATED CHASSIS PUMP
50:1 RATIO, OUTPUT – 80 CU. IN./MIN.
MIN. AIR PRESSURE – 30 PSI
MAX. AIR PRESSURE – 120 PSI
MAX. OUTPUT PRESSURE – 7500 PSI
OWNERS MANUAL
RECOMMENDED OPERATING PRESSURE 80-100 PSI
GREASE TYPE: NLGI #2
(maximum for effective performance)
RETAIN THIS MANUAL FOR FUTURE REFERENCE TO IMPORTANT WARNINGS AND
OPERATING AND MAINTENANCE INSTRUCTIONS.
PROPER USE AND MAINTENANCE OF THIS EQUIPMENT IS THE RESPONSIBILITY OF THE
OWNER AND/OR OPERATOR.
DO NOT USE THIS EQUIPMENT UNLESS YOU HAVE CAREFULLY READ AND
UNDERSTAND THE INSTRUCTIONS AND WARNINGS IN THIS MANUAL.
! WARNING !
NEVER exceed the stated maximum working pressure of the pump or of the lowest rated component in your
system.
NEVER modify any part of this equipment.
NEVER use combustible gas with this equipment.
NEVER attempt repairs while the system is under pressure.
NEVER attempt to disassemble the equipment while the system is under pressure.
ALWAYS tighten fluid connections before using this equipment
ALWAYS read/follow the fluid manufacturer's recommendations regarding fluid compatibility.
ALWAYS read/follow the fluid manufacturer's recommendations regarding the use of protective clothing
and equipment.
ALWAYS use an air line filter/moisture eliminator at the air inlet for the pump.
ALWAYS use air line lubrication.
REGULARLY check all equipment and repair/replace worn or damaged parts immediately.
FAILURE TO HEED THESE WARNINGS INCLUDING OVERPRESSURIZING,
ALTERING PARTS, USE OF INCOMPATIBLE FLUIDS, MISUSE, OR USE OF
DAMAGED/WORN PARTS MAY RESULT IN EQUIPMENT DAMAGE,
PROPERTY DAMAGE, FIRE, EXPLOSION AND/OR SERIOUS PERSONAL
INJURY.
SAFETY INSTRUCTIONS
Extreme caution should be used when operating this equipment as it generates very high fluid pressure.
Leaks from loose or ruptured components or material from dispensing valve can inject fluid through the skin
causing serious bodily injury and possible need for amputation. Always wear protection to prevent material
splashing onto skin or into eyes.
IMPORTANT: GET EMERGENCY MEDICAL CARE IMMEDIATELY IF ANY FLUID APPEARS TO
PENETRATE THE SKIN! INFORM PHYSICIAN OF EXACTLY WHAT WAS INJECTED. PLEASE
DO NOT TREAT THIS INJURY AS A SIMPLE CUT.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ATD5217 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ATD Tools ATD5217

  • Page 1 ATD5217 FOR 120 LB. DRUMS MADE IN MEXICO AIR OPERATED CHASSIS PUMP 50:1 RATIO, OUTPUT – 80 CU. IN./MIN. MIN. AIR PRESSURE – 30 PSI MAX. AIR PRESSURE – 120 PSI MAX. OUTPUT PRESSURE – 7500 PSI OWNERS MANUAL RECOMMENDED OPERATING PRESSURE 80-100 PSI...
  • Page 2: Pressure Relief Procedure

    ! WARNING ! – RELIEF PROCEDURE DO NOT EVER point the dispensing valve at another person. DO NOT EVER attempt to stop material from the dispensing valve or a leaking connection with your hand or body. BEFORE EACH USE, check equipment for proper operation and to insure safety devices are in place and working properly.
  • Page 3 Install the extention tube (10181) into the air inlet port of the air motor. You might need Teflon tape to ensure a leak-free connection. Place air motor (91407) on pump head (ATD5217-1). Place washer (33034) and cover nut (11478) on pump stud and thread air motor cover securely in place.
  • Page 4: Test The System

    Allow pump to operate: Pumping Grease into the hose. Allow approximately 1/3 Cup of Grease to flow out of the Hose. This is to insure that any particles or contaminants or residue inside the hose do not enter the ATD5218 Control Valve. Stop Pump; Install the ATD5218 Control Valve on the hose; The optional “Z” swivel (ATD5253) can also be installed at this time.
  • Page 5: Question: Answer

    Trouble Shooting Guide for Pumps ATD5217 – ATD5219 –ATD5289 PROBLEM: SOLUTION: consider the pump to be live Warning: If the Air is connected to the pump, . Do not attempt to work on the pump or the system without disconnecting the Air Inlet and relieving pressure in the system, both air pressure and lube pressure.
  • Page 6 QUESTION Does the pump Air Motor Yes? Then put the pump back in the No? Check Air Inlet for Pressure, operate when it is removed grease. Remove the hose from the pump and check Air Motor for Leaks at from the Grease? the Air Nipple, Muffler or Seals.

This manual is also suitable for:

Atd5219Atd5289Atd5217-1

Table of Contents