Maintenance And Troubleshooting - Pro-Form 745 EKG User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and tighten all parts of the exercise cycle reg-
ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a
small amount of mild detergent. Important: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
• Avoid moving your hands or holding the metal con-
tacts too tightly whilst using the handgrip pulse sen-
sor. Excessive movement or pressure may interfere
with heart rate readings.
• For the most accurate heart rate reading, hold the
metal contacts for about 15 seconds.
• Keep the metal contacts clean. The contacts can be
cleaned with a soft cloth—never use alcohol,
abrasives, or chemicals.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (17) must be
removed. Remove the seven Screws (52) from the
Right Side Shield (18). Next, remove the Screw (59)
from the right side of the Side Shield Cover (19).
52
All manuals and user guides at all-guides.com
19
52
18
59
Using an adjustable wrench, turn the Left Pedal (24)
clockwise and remove it. Next, remove the two
Screws (66) from the Left Side Shield (17). Remove
the Screw (59) from the left side of the Side Shield
Cover (19) and lift it off. Gently remove the Left Side
Shield.
19
59
66
Next, locate the Reed Switch (43). Turn the Left
Crank Arm (42) until the Magnet (38) is aligned with
the Reed Switch. Loosen but do not remove the
Screw (66). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield, side
shield cover and the pedal.
38
43
66
BATTERY REPLACEMENT
If the console display becomes dim, the batteries
should be replaced; most console problems are the
result of low batteries. See assembly step 4 on page
6 for replacement instructions.
19
24
17
42