Invacare LiNX DLX-REM110 User Manual page 31

respond to any commands except for its ON/OFF button,
which can always turn off the system.
Powering up
Either of the remotes can power up the system with their
own ON/OFF button. The remote that powers up the
system has control of the system (remote-in-charge). The
other remote (remote-not-in-charge) has no control of the
wheelchair except for its ON/OFF button, which can still be
used to power down the system.
The system is automatically powered up in drive function
one. As an attendant you cannot change the drive function.
You can just control the maximum speed with the speed
dial on the attendant remote.
Powering down
No matter which remote is in charge in the dual remote
system, the wheelchair can be powered down by pressing
the ON/OFF button on either remote.
Changing who's in charge
To change which remote is in charge, power down the
system with either remote, and then power up the system
again with the remote that requires the control.
1602969-F
Remote-in-charge indication
Remote-in-charge
All indicators, including the
battery gauge displays as
normal.
Fault handling and indication
If a fault is present on one of the remotes in a dual remote
system, the fault is indicated on both remotes.
If one of the remotes in a dual system is faulty, the system
can be driven with the other remote. If, however, the
ON/OFF button on the remote-in-charge has a fault, the
system does not operate.
If one of the remotes is disconnected from the system
when it is powered down, the remaining remote displays
a fault (refer to Flash code 2 in chapter 6.1.1 Fault codes
and diagnosis codes, page 32) when the system is powered
up again to indicate that it was expecting two remotes in
the system. To clear the fault, cycle the power with the
ON/OFF button.
Remote-not-in-charge
The battery gauge is
switched off and all other
indicators operate normally.
Usage
31