Escort Passport SR1 User Manual page 11

Power-on Sequence
PwrOnSTD (standard)
In this setting, each time you turn on Pass-
port, it will display "Passport", "SR-1",
"LASER", "Ka-band", "K-band", "X-band",
followed by a brief X-band alert. It then
confirms connections to the front and rear
receivers, and will display "Rear OK", and
"Front OK." (factory default)
NOTE:
If there is a problem with the rear receiver
or wiring after the initial start-up sequence,
Passport will briefly display "Rear N/A",
but will continue to operate with the front
receiver.
If there is a problem with the front receiver
or wiring after the initial start-up sequence,
Passport will display "FrontN/A", and will
then continue to display "Check", "Receiver",
"Wiring". Passport will not operate in this
condition.
PwrOnFST (fast power-on)
This setting shortens Passport's start up
sequence by eliminating the words "Pass-
port", "SR-1", "LASER", "Ka-band", "K-band",
"X-band", from the start-up sequence above.
Details of EZ Programming Options
Signal Strength Meter
MeterSTD (standard meter)
The meter displays the band, and bar graph
showing signal strength. (factory default)
MeterEXP (ExpertMeter)
The meter simultaneously tracks up to 2
Ka-band, 2 K-band, and 4 X-band signals.
Note: See more details on pages 6-7.
AutoMute
aMute ON (AutoMute on)
In this setting, Passport's audio alerts will
initially be at the volume you set, but after
a few seconds, Passport will automatically
reduce the volume level, to keep you in-
formed, but not annoyed. (factory default)
aMuteOFF (AutoMute off)
With AutoMute off, Passport's audio alerts
will remain at the volume you set for the
duration of the radar encounter.
Audio Tones
Tone STD (Standard tones)
This setting uses more pleasing tones. (fac-
tory default)
ToneLOUD (Loud tones)
This setting uses tones that are more pierc-
ing, and easier to hear in a louder vehicle.
11