Advertisement
Quick Links
IMPORTANT SAFETY INSTRUCTIONS
WARNING
If the instructions contained in this manual are not followed
precisely, fire or explosion may result causing property
damage, personal injury or loss of life.
- Do not store or use gasoline or other flammable vapors or
liquids near this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switches.
• Do not use any telephones in your building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire
department.
- Installation and service must be performed by a qualified
installer, service company or gas supplier.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A
QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR THE LOCAL INSPECTOR'S USE.
Table of Contents
12
12
15
17
18
21
29
32
3
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Smeg Professional Series
Summary of Contents for Smeg Professional Series
-
Page 1: Table Of Contents
Table of Contents 1 Installation 1.1 Product dimensions 1.2 Unpacking, moving and positioning the range 1.3 Electrical connection 1.4 Gas connection 1.5 Conversion to propane gas (LPG) 1.6 Wall and floor attachment 1.7 For the installer IMPORTANT SAFETY INSTRUCTIONS WARNING If the instructions contained in this manual are not followed precisely, fire or explosion may result causing property damage, personal injury or loss of life. - Page 2 Important Safety Instructions Important Notes to the Installer TIP OVER HAZARD • Read all instructions contained in these installation instructions WARNING: Tip Over Hazard before installing the range. • Remove all packing material from • A child or adult the oven and the drawer could tip the compartments before connecting range over and...
- Page 3 Important Safety Instructions • Check for proper installation and • Unit is heavy and requires at least use of the anti-tip bracket. two persons or proper equipment Carefully tip the range forward by to move. pulling it from the back to ensure •...
- Page 4 Important Safety Instructions • The appliance must be electrically grounded in accordance with local codes or, in the absence of WARNING local codes, with the National Electrical Code, NFPA 70 latest Never leave children alone or edition or, in Canada, the unattended in the area where an Canadian Electric Code, CSA appliance is in use.
- Page 5 Important Safety Instructions • Do not store or use gasoline or other flammable vapors and liquids near this or any other WARNING appliance. Explosions or fires could result. Do not repair, replace or remove any • Adjust the size of the surface part of the appliance unless specifically burner flame so that it does not recommended in the manuals.
- Page 6 Important Safety Instructions • Before installing, turn power OFF Gas safety at the service panel. Lock service panel to prevent power from WARNING being turned ON accidentally. • For appliances equipped with a Burning gas cooking fuel generates some cord and plug, do not cut or by-products which are on the list of remove the ground prong.
- Page 7 Important Safety Instructions • The minimum supply pressure must Propane Gas Installation be 1" water column above the • The propane gas tank must be manifold pressure printed on the equipped with its own high rating label. The maximum supply pressure regulator.
- Page 8 Important Safety Instructions Related Equipment Safety • When installing a cooktop over a single oven, be sure to follow • The appliance should only be both the oven’s and cooktop’s used if installed by a qualified installation manuals. technician in accordance with these installation instructions and Ventilation Recommendations all applicable regulations and...
- Page 9 Important Safety Instructions CAUTION WARNING The appliance should not be installed If the information in this manual is not with a ventilation system that blows air followed exactly, fire or shock may result downward toward the burners. This type causing property damage or personal of ventilation system may cause ignition injury.
-
Page 10: Installation
Installation 1 Installation 1.1 Product dimensions Overall dimensions: Location of gas and electrical connection points. 608 mm " 25” 630 mm 1088 mm " 849 mm " 130 mm " Measurement M varies according to the model: the minimum is obtained without the 32 mm "... - Page 11 Installation Cabinet clearances min. clearance from the sides of range to side wall or other combustible material; min. cabinet opening width; upper cabinet to countertop; max. upper cabinet depth. The side cabinet depth (clearance B) must match the front edge of the range side panel.
- Page 12 Installation Location of the gas and electric Keep a minimum clearance of 5 7/8" (150 outlets mm) between the appliance and the other furnishings or decorative elements according to the diagram below. 10” 254 mm 5” 127 mm 8” 203 mm 5”...
-
Page 13: Unpacking, Moving And Positioning The Range
Installation 1.2 Unpacking, moving and • Ensure that the burner caps are correctly positioned on the burner bases on the positioning the range rangetop. • Legs should be installed near to where CAUTION the appliance will be used as they are not secure for long transit. - Page 14 Installation The appliance must sit level on the floor to ensure stability: • Screw or unscrew the bottom part of the foot until the appliance is stable and level on the floor. The adjustment range of the screw is 1 “...
-
Page 15: Electrical Connection
Installation 1.3 Electrical connection WARNING WARNING Electrical shock hazard • Disconnect the electrical supply before Electrical shock hazard servicing the appliance •This appliance is • It is the personal responsibility of the equipped with a three- consumer to have the appropriate outlet prong grounding plug for or junction box with the correct, properly your protection against... -
Page 16: Gas Connection
Installation These ID plates must never be removed. 1.4 Gas connection WARNING: Explosion hazard • Use a new AGA or CSA-approved gas supply line. • Install a shut-off valve. • Securely tighten all gas connections. • lf connected to propane, have a qualified technician ensure that the gas pressure does not exceed a 14"... - Page 17 Installation To convert the appliance to propane gas see "Conversion to propane gas (LPG)". The conversion must be done by a qualified CAUTION technician or installer. Use a flexible gas pipe with a length of at least 5 ft (1.5 m). The gas inlet to the unit is located at the Do not allow regulator to rotate on pipe when tightening fittings.
- Page 18 Installation 4. Retest for leaks. If no bubbles appear, • Dual Flame burner: the test is passed. Wipe off all residues of detection fluid. Testing the electric ignition of the burner This test should be performed after the range and supply line connectors have been carefully checked for leaks and the range connected to the electric power supply:...
-
Page 19: Conversion To Propane Gas (Lpg)
Installation 1.5 Conversion to propane gas (LPG) This appliance is shipped from the factory for use with natural gas. Use this kit to convert the appliance for use with propane WARNING gas, if necessary. Comply with the following: Ensure that the range is converted for use with the appropriate gas This conversion kit shall be installed by a qualified service agency in accordance... - Page 20 Installation List of components This conversion kit consists of the following CAUTION components: Before proceeding with the gas conversion, the gas supply must be turned off before disconnecting the electrical power. Setting the pressure regulator for propane gas To convert the regulator to the type of gas used, the following must be done: 1.
- Page 21 Installation Replacing the rangetop's burners One warning label change injectors nozzles 1. Remove all the grates and all the burner caps (1) and heads (2); • One seal gasket 12.5x18.5x2 (mm). 2. Unscrew the burner nozzles with a 7 mm socket wrench;...
- Page 22 Installation Rapid burner Unscrew the burner nozzles with a 7 mm socket wrench and replace them according to the type of gas to be used and the description in section “Burner and nozzle characteristics tables”. 3. Refit the burner components correctly. Replacing the oven burner nozzle 1.
- Page 23 Installation Minimum adjustment for propane 7. Replace the nozzle using a 7mm socket wrench. gas: Replacing the gas grill nozzle Turn off the burners and unplug the appliance from the electrical power supply. 1. Open the door. For regulating the minimum with propane, 2.
- Page 24 Installation Burner and nozzle characteristics tables To adjust the range for propane gas or to return to Natural Gas use, refer to the charts below. Natural Gas DUAL int DUAL est Oven Broiler QT (BTU) 10000 12000 18000 9000 9000 Injector Ø...
- Page 25 Installation • Connect the gas supply line to the unit 4. Retest for leaks by turning the gas supply pressure regulator using a 1/2” flex gas line shutoff valve on. When the leak line connector between the manual shut- check has been completed (no bubbles off valve and the pressure regulator.
- Page 26 Installation • Save the nozzles removed from the unit Conversion to natural gas along with these instructions for possible This appliance is shipped from the factory future use. for use with natural gas. If the appliance has • For installation of the appliance at high been converted to propane gas before, altitude, please consult your local gas you have to convert it to natural gas again.
-
Page 27: Wall And Floor Attachment
Installation 1.6 Wall and floor attachment Installing the anti-tip bracket 1. Ensure that the electrical connection is in the correct position. WARNING 2. Assemble the bracket. Electrical shock hazard •Use extreme caution when drilling holes in the wall or floor. There may be concealed electrical wiring behind the wall or under the floor. - Page 28 Installation 7. Use the following distances for the NOTE: The wall attachment is distance from the side of the appliance recommended if the appliance is to the bracket holes. placed against a wall. Floor attachment is recommended in case of island installation. 5.
- Page 29 Installation Door removal It is not necessary to remove the door in WARNING order to install the range, but is an added convenience. Refer to the Use and Care The rear vent trim has ” (5 mm) Guide for the oven door removal instructions.
-
Page 30: For The Installer
Installation 1.7 For the installer • The plug must remain accessible after the installation is complete. Do not kink or trap the mains connection cable. • The appliance must be fitted according to the installation diagrams. • When satisfied with the appliance, please instruct the user on the correct method of operation.
Need help?
Do you have a question about the Professional Series and is the answer not in the manual?
Questions and answers