Advertisement
You should replace the stylus on the pick-up after about 250 operating hours in
order to maintain the playback quality and avoid damage to your records.
1. Push the tone arm locking lever to the left.
2. Remove the protective cap, if necessary, by pulling it downwards from the
pick-up system.
3. Pull the stylus together with its holder forwards and away from the pick-up
system.
i
If the pick-up system needs to be replaced, please contact the Service
Centre.
FCC NOTICE
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID
THE USER AUTHORITY TO OPERATE THE EQUIPMENT.
Changing the stylus
4. Push the new stylus together with its holder onto
the pick-up system from the front.
UK - 20
Advertisement
