Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Oru Kayak HAVEN TT
Summary of Contents for Oru Kayak HAVEN TT
- Page 1 SCAN AND WATCH ON YOUR PHONE Assembly Guide (Pages 1-16) Disassembly Guide (Pages 17-20) Read this entire Assembly Watch the instruction video: IMPORTANT Guide before assembling www.orukayak.com/assembly/haventt your Oru Kayak. SERVICE@ORUKAYAK.COM...
-
Page 2: Getting Familiar
Connect to the seat Reinforces kayak bottom and column holding the holds the rear and middle seat. seat system in place. Crossbar Alignment Icon: This arrow indicates the correct place to install the crossbar. ORU KAYAK | HAVEN TT ASSEMBLY GUIDE... - Page 3 Getting Familiar assembly components Stern backrest: Includes the Backrest seat column and adjustable backrest. (Note: This backrest is used Shoulder strap: Used to carry the in both the tandem and single paddler kayak when in box form. Stow out Seat column configuration.) of the way while kayaking.
-
Page 4: Step 1: Open The Box
Unclip the buckles on the sides. Remove the loose kayak components packed into the box. [See page 5 for a list of loose components.] Additional components are permanently attached to the hull/deck. ORU KAYAK | HAVEN TT ASSEMBLY GUIDE... - Page 5 Step 2: Unfold the box Hold the two folds at the orange stickers. Pull as indicated in the illustration to open. The skin will be stiff. Pull the two flaps indicated in the diagram out to extend the box into a long sheet. Pop the hull flat with your hands as you extend it, pushing down the inverted...
- Page 6 (see 3A1.) Attach velcro to the top of the bulkhead, as shown in close- Stretch front fairing over the bow, and clip the small buckle onto last deck strap and tighten. ORU KAYAK | HAVEN TT ASSEMBLY GUIDE...
- Page 7 Step 4: Close the back of the kayak Closing the back of the kayak is similar to closing the front (Step 3). s c r e w ( b e h i v e l c r n d ) ( f r o n Place the loose stern bulkhead in bulkhead channels as shown...
- Page 8 Your floorboards will look like this when properly installed. STERN The floorboards will be curved upwards at this point. Press the center of both floorboards down at the same time. CROSS-SECTION VIEW ORU KAYAK | HAVEN TT ASSEMBLY GUIDE...
- Page 9 For tandem assembly reference pages 11-13 For single paddler assembly reference pages 14-15 WWW.ORUKAYAK.COM...
- Page 10 Connect the green seat back buckles to the same bowtie as the bow footrest (blue and green bowtie). Insert the seat pad under the front bungee. ORU KAYAK | HAVEN TT ASSEMBLY GUIDE...
- Page 11 Step 6: Insert the stern seat/the footrest TANDEM STERN Insert the other seat into the rear Connect the footrest attached Insert the seat pad under the most seat column plate. Connect to the front seat to the green rear bungee. seat back buckles to the stitching female buckle in the rear same bowtie as the stern footrest.
-
Page 12: Final Adjustments
Congratulations! Tighten, or loosen the seatback straps, while leaning against the backrest. Your Oru Haven TT is ready for the water. The footrest should keep your legs WARNING comfortably bent, `with your knees splayed Do NOT attempt to carry the assembled outward. - Page 13 SINGLE PADDLER ASSEMBLY - CONTINUING FROM PAGE 9 Step 6: Insert the stern seat/the footrest SINGLE Loosen the knobs two full turns. Slide the crossbar onto the track using the graphics on the floorboard to align. Tighten down the knobs when aligned. STERN Using the buckles on the bow (front) blue...
-
Page 14: Assembly Checklist
The footrest should keep your legs comfortably bent, `with your knees Congratulations! splayed outward. To adjust the front Your Oru Haven TT is ready for footrest, tighten or loosen adjustable WARNING the water. straps. -
Page 15: Disassembly Guide
Some water may collect inside the plastic corrugated flutes. To let it drain, stand the assembled kayak vertically for about 10 minutes. Read this entire Assembly Watch the instruction video: IMPORTANT Guide before assembling www.orukayak.com/assembly/haventt your Oru Kayak. SERVICE@ORUKAYAK.COM WWW.ORUKAYAK.COM... - Page 16 Back on land: Folding your Oru Kayak into its box Disassembling the Oru Kayak is basically a reversal of the assembly; however there are a few tricks. Follow these simple directions to learn how to pack your Oru Kayak back into its box quickly and easily. LIFT...
- Page 17 Back on land: Folding your Oru Kayak into its box CLOSE-UP Fold either bow or stern FOR STEP-BY-STEP VIDEO INSTRUCTION Make sure the inverted fold is flat inward like an accordion. WATCH THE ASSEMBLY VIDEO: when folding your boat up. The end Using your knee helps! www.orukayak.com/pages/assembly...
- Page 18 Back on land: Folding your Oru Kayak into its box Place the shoulder strap plate under kayak box. Attach the shoulder strap assemble around the boat and tighten. Place the stern floorboard (has two Place the footrest and bulkhead into...
- Page 19 WE ARE HERE TO HELP For product or assembly questions contact us: service@orukayak.com (415) 630-3717 WWW.ORUKAYAK.COM...
Need help?
Do you have a question about the HAVEN TT and is the answer not in the manual?
Questions and answers