Table of Contents
Advertisement
INSTALLATION AND OPERATION MANUAL, GAS SKILLETS, MODELS GMTS-(30, 40, 60)
GAS CONNECTIONS (Continued)
After piping has been checked for leaks, all piping receiving gas should be fully purged to
remove air.
WARNING: Never use an open flame to check for gas leaks. Check
all connections for leaks using soapy water before use.
NOTICE: If this equipment is being installed at over 2,000 feet altitude and was
not so specified on order, contact service department. Failure to install with
proper orifice sizing may void the warranty.
CAUTION: The pipe thread compound used when installing pipes
must be a type that is resistant to the action of liquified petroleum or
propane gases.
Part No. 10094R2
8
2019-01-16
Advertisement
Table of Contents
