Safety System - TEFAL Frutelia Manual

• Do not immerse the motor unit or put it under running water.
• Use this appliance on a solid, stable worktop, away from water splashes.
Do not turn it over.
• Any intervention other than normal cleaning and maintenance by the
customer must be carried out by an approved service centre.
• Never unplug the appliance by pulling on the cord.
• Do not use an extension lead. If you accept liability for doing so, only
use an extension lead which is in good condition, has a plug with an
earth connection and is suited to the power rating of the appliance.
• A domestic appliance must not be used:
– if it has fallen on the floor
– if it is damaged or incomplete.
• Do not use your appliance if it does not operate correctly, if it has been
damaged or if the power cord or plug is damaged. To maintain safety,
these parts must be replaced by an Approved Service Centre.
• In such cases, or for any other repair, you must contact an Approved
Service Centre.
• This product has been designed for domestic use only. The manufacturer
accepts no responsibility, and the guarantee will not apply, for any
commercial use, inappropriate use or failure to comply with the
instructions.
• Only use original accessories and components. We cannot accept any
responsibility if this is not the case.
• Never put your fingers or any other object in the filler tube while the
appliance is in operation. Always use the pusher provided for this
purpose.
• Never open the cover before the sieve has come to a complete stop.
• Do not remove the pulp collector while the appliance is in use.
• Always unplug the appliance from the mains after use.
• Do not leave the power cord close to or in contact with sources of heat
or sharp edges.
• Do not allow long hair, scarves, ties etc. to hang over the appliance or
attachments when in use.
• Wait for all moving parts to stop before opening the appliance.
• Do not exceed the maximum quantities or operating periods indicated.

SAFETY SYSTEM

• To start the juicer, the cover (C) must be fitted correctly
At the end of a cycle, turn the control button to "0" and wait until the
sieve (D) stops completely before removing the cover (C).
3
(Fig. 2).