Satel SATELLINE-M3-R9 Integration Manual page 43

RadioFreq SL&-=nnnn
RadioFreq SL&B?
RadioFreq SL&B=z
RadioFreq SL&C?
RadioFreq SL&X=nnn.nnnn
RadioFreq SL&E?
RadioFreq SL&F?
RadioFreq SL&F=nnn.nnnnn
RadioFreq SL&FR?
RadioFreq SL&FR=nnn.nnnnn
RadioFreq SL&FT?
RadioFreq SL&FT=nnn.nnnnn
RadioFreq SL&N?
RadioFreq SL&W?
RadioFreq SL&W=xxxx
RadioProperty SL%F?
RadioProperty SL%F=x
For conventional reasons, only 2 or 4
digit inputs are valid
Set active frequency nnnn channels
below center frequency.
Frequency = Center frequency –
nnnn*Channel spacing
Value of nnnn is [0...number of
channels/2]
For conventional reasons, only 2 or 4
digit inputs are valid
Get active subband
Set frequency band. Value of z is:
"1" 869.4-869.65MHz, 500mW, 10%
"2" 869.65-869.7MHz, 25mW, 10%
"3" 869.7-870MHz, 25mW, 1%
"4" 868-868.6MHz, 25mW, 1%
"5" 868.6-868.7MHz, 10mW, 1%
"6" 869.3-869.4MHz, 10mW, 1%
Get center/reference frequency
Set center/reference frequency
Get Enabled Channel Widths
Get active frequency
Set active frequency to nnn.nnnnn
MHz
Get Rx frequency
Set Rx frequency to nnn.nnnnn MHz
Get Tx frequency
Set Tx frequency to nnn.nnnnn MHz
Get active channel calculated from
center frequency ( = (active frequency
– center frequency)/channel spacing )
Get channel spacing/channel width
Set channel spacing. Value of xxxx is:
"2500" for 25 kHz
Command is supported only by
hardware variants with adjustable
channel spacing.
Get status of Error correction (FEC)
Set Error correction (FEC). Value of x is:
"1" Set FEC ON
"0" Set FEC OFF
42
SATELLINE-M3-TR8 /-TR9 / -R9
Integration Guide, Version 2.2
"OK" or "ERROR"
Subband Number,Min
Freq,Max Freq,Max
Power,Duty cycle
For example: "1, 869.40000
MHz, 869.65000 MHz, 500 mW,
10%"
"OK" or "ERROR"
"nnn.nnnnn MHz"
"OK" or "ERROR"
List of supported Channel
widths e.g. "12.5 kHz, 20.0
kHz, 25.0 kHz"
TX nnn.nnnnn MHz,
RX nnn.nnnnn MHz
"OK" or "ERROR"
"nnn.nnnnn MHz"
"OK" or "ERROR"
"nnn.nnnnn MHz"
"OK" or "ERROR"
decimal number "+nnnn", "-
nnnn", "+nn" or "-nn"
"25.0 kHz"
"OK" or "ERROR"
"0" = FEC OFF ,
"1" = FEC ON
"OK" or "ERROR"