Download Print this page

Epson Duet Quick Start Manual page 4

Epson duet projector screen: quick start
Hide thumbs Also See for Duet:

Advertisement

3
Mounting the Screen on the
Wall
Montage de l'écran au mur
Attach the wall mount
Fixez le support mural
1
Choose a location for your screen, allowing enough room for it when
open. Depending on your viewing needs, you can open it to either
width shown below.
Sélectionnez un emplacement pour l'écran, en prévoyant un
dégagement suffisant pour son ouverture. Selon vos besoins,
vous pouvez l'ouvrir partiellement à l'une ou l'autre des largeurs
indiquées.
Note: Use these dimensions to make sure you have enough room
for your screen.
Remarque : Référez-vous à ces dimensions pour confirmer que
vous avez suffisamment d'espace pour l'écran.
1
42
/
inches
2
108 cm
2
Determine the screen's center point on your wall and mark that
location.
Déterminez le point central de l'écran au mur et marquez-le.
3
Position the wall mount over the center mark as shown below. Make
sure the slotted anchor bolt hole is at the bottom.
Positionnez le support mural sur la marque centrale tel qu'indiqué
ci-dessous. Assurez-vous que le trou de boulon d'ancrage fendu se
trouve au bas.
Attach anchor bolts here
Fixez les boulons
d'ancrage ici
4
Attach the wall mount using two anchor bolts at the points shown
above. Tighten the bolts snugly.
Installez le support mural à l'aide des deux boulons d'ancrage aux
points indiqués ci-dessus. Serrez bien les boulons.
Note: For drywall installation, use the anchor bolts included with
the screen. You may need different hardware if your setup varies
(for example, if you attach the wall mount directly to a stud, or to a
concrete or masonry wall).
Remarque : Pour installation sur une cloison sèche, utilisez les
boulons d'ancrage fournis avec l'écran. Il peut être nécessaire
d'utiliser un nécessaire de montage différent, par exemple, si vous
fixez le support mural directement sur un goujon ou sur un mur en
béton ou en maçonnerie.
The lower slot lets you adjust the screen's horizontal alignment. Check the
alignment as described in the next section before inserting the four corner
screws.
La fente inférieure vous permet de régler l'alignement horizontal de
l'écran. Vérifiez l'alignement tel que décrit ci-dessous avant d'insérer les
quatre vis d'extrémité.
3
61
/
inches • 157 cm
4
(4:3 position • position 4:3)
1
79
/
inches • 202 cm
2
(16:9 position • position 16:9)
Center point
Point central
Center mark on wall
Marque centrale sur
le mur

Advertisement

loading