Brother HL-2400C Service Manual page 139

11)Press the Continue button to implement FLASH CARD2 R/W TEST.
CARD2 R/W OK:
CARD2 R/W ERROR:
NO FLASH CARD2:
WP FLASH CARD2:
12)Press the Continue button to implement the MIO CHECK.
MIO OK:
MIO ERROR:
NO MIO BOARD:
13)Press the Continue button to exit the Line Test Mode. The printer is reset as
follows;
14)Turn off the power.
C A R D 2 R / W S T A R T
C A R D 2 R / W O K
The flash memory card works correctly.
The flash memory card has a problem.
The flash memory card is not installed.
The write protect switch on the flash memory
card is On.
M I O C H E C K S T A R T
M I O O K
The MIO card works correctly.
The MIO card has a problem.
The MIO card is not installed.
R A M S I Z E = 1 6 M
N o w i n i t i a l i z i n g
L J W A I T 0 0 1 P T 1
L J R E A D Y 0 0 1 P T 1
V-7
When this messages is
displayed, the printer may
be turned off.
However, if one of the
toner cartridges is not
installed or no paper is
loaded, a message such
as "14 NO CARTRIDGE"
or "CHECK TRAY" is
displayed.