Antenna Setting Command; Radio Wave Transmission On/Off - Omron V690 Series User Manual

5-9 Antenna Setting Command

5-9-1 Radio Wave Transmission ON/OFF

Specifies the radio wave transmission OFF mode and radio wave transmission ON mode of an antenna. (Refer to (2) in Section 5-2-3.)
This command can be used in the operation mode, not in the setting mode. (Refer to Section 5-1 and (3) in Section 5-4.)
When the power supply is reset or a reset command is executed, the radio wave transmission OFF mode which is initial value is enabled.
<Command Format> * A figure below shows the number of characters.
Command
code
DA
SA
Command code
<Response Format> * A figure below shows the number of characters.
Command Termination
code code
DA
SA
Termination code
(BCC)
* It can be specified whether BCC is enabled or disabled.
Destination (antenna) station number. "00" to "31". This can
be modified in "5-9-8 Station Number Setting".
Source (host device) station number. "80" to "89". If only one host device is used, specify
"80".
A0: Specifies the radio wave transmission OFF mode.
A1: Specifies the radio wave transmission ON mode.
(BCC)
* It can be specified whether BCC is enabled or disabled.
Destination (host device) station number. * In the command format, the destination is an
antenna.
Source (antenna) station number.
Fixed to "00".
Initial value "00"
Initial value is the radio
wave transmission OFF
mode.
5-35