Chapter 6 From Startup To Run; Trial Operation - Omron V690 Series User Manual

Chapter 6 From Startup to Run

6-1 Trial Operation

♦ ♦ ♦ ♦ Items to be checked
Before performing a trial operation, check the following items:
No. Items to be checked
1 Installation environment of
antenna and tag
2 Installation of antenna and tag
3 Connection of antenna and dedi-
cated cable
4 Connection to host device
5 Installation of link unit for RS-
422A and RS-485
♦ ♦ ♦ ♦ Trial operation procedure
Turns on the power supply.
Simplified communication test
Communication test
Trial operation for system.
End.
♦ ♦ ♦ ♦ Simplified communication test
The communication between an antenna and tag can be tested without connection to a host device. Use this test to check the location of
antenna and tag. For how to operate, refer to Section 3-4.
♦ ♦ ♦ ♦ Communication test
The connection to a host device is made and the "Communication Test" command is sent from the host device to an antenna. Commu-
nication cable connection, communication processing, communication status between the antenna and tag can be checked. For how to
operate, refer to Section 3-5.
Whether the installation environment is suitable.
Whether the antenna and tag are installed correctly.
Whether the connector is connected properly.
• Whether RS-232C, RS-422A and RS-485 are connected
properly.
• Whether connected to 24 VDC power supply.
• Whether installed.
• Whether "+P" and "-P" are connected.
Whether the link unit is installed correctly.
• Check the power supply voltage and power supply terminal connection.
• Check whether the antenna indicator POWER LED turns on.
Check the communication between an antenna and tag without connection to a host
device (or with connection to the host device).
Check the communication between a host device and antenna and between an antenna and tag.
Check a total system operation with an actual command.
Checking Page
Section 4-1-1
Sections 4-1-2
and 4-1-3
Section 4-1-4
Section 4-2
Section 4-3
6-1