Antenna Operation Command; Auto Repeat Cancel - Omron V690 Series User Manual

5-8 Antenna Operation Command

5-8-1 Auto Repeat Cancel

Cancels the Auto or Repeat command during the execution of the command. Then, an antenna waits for a command.
<Command Format> * A figure below shows the number of characters.
Command
code
DA
SA
Command code
<Response Format> * A figure below shows the number of characters.
Command Termination
code code
DA
SA
Termination code
(BCC)
* It can be specified whether BCC is enabled or disabled.
Destination (antenna) station number. "00" to "31". This can
be modified in "5-9-8 Station Number Setting".
Source (host device) station number. "80" to "89". If only one host device is used, specify
"80".
C2
(BCC)
* It can be specified whether BCC is enabled or disabled.
Destination (host device) station number. * In the command format, the destination is an
antenna.
Source (antenna) station number.
Fixed to "00".
Initial value "00"
5-31