Wieland ricos FLEX BC MODBUS User Manual page 43

Configuration
Each ricos FLEX module has a unique identification number – module ID. The modules are listed on
the web server by means of their module ID. As soon as a module is configured, the ID of the corre-
sponding module is listed. In this dialog field you have the possibility to store the current module
configuration or to import a module configuration. With [Delete] the parameterization of all the
modules may be deleted in the Ethernet coupler.
•
•
Please consider that controlling of output values represents a potentially dangerous condition.
•
As long as Commissioning state is activated, set variables retain their value.
•
Commissioning state should only be used for test purposes respectively for troubleshooting.
CAUTION
•
•
•
•
•
Only there is a configuration for a module, this may be used to check preset and current configura-
NOTICE
tion. If the current configuration differs from the preset (e.g. module was removed) the system re-
ports an error and does not go to RUN. If there is no preset module configuration and the current
configuration is changed during operation, the ricos FLEX BC MODBUS performs a restart and
switches again to RUN.
Wieland Electric GmbH | BA001269 | 09/2021 (Rev. A)
'Activate Commissioning mode'
o
With [Activate], the Ethernet coupler enters the Commissioning state.
BASP (Befehlsausgabesperre i.e. command output disable) is not activated, i.e.

all module outputs can be controlled and the inputs can be read.
When changing to the 'Commissioning' state, all outputs are reset.

o
In the Commissioning state you have the following options:
Outputs can be set via the web page in the 'Data' tab of the selected module.

Parameters can be written via the web page in the 'Parameter' tab of the se-

lected module.
o
With [Deactivate] you leave the Commissioning state:
BASP is activated, i.e. all module outputs are switched off and the inputs are not read.
'Export station configuration'
o
With [Save] a window is opened and shows the configuration as XML. Select 'File
Safe as' and safe the current configuration as XML file.
'Import station and modules configuration'
o
Select with [Search...] the according XML file and load this with [Load]. While loading
the parameters of the ricos FLEX BC MODBUS and the modules are loaded.
'Import modules configuration'
o Select with [Search...] the according XML file and load this with [Load]. While loading
only the parameters of the modules are loaded. The parameters of the ricos FLEX BC
MODBUS further exist.
'Save configuration of all modules'
o
With [Save] the current configuration is stored in the ricos FLEX BC MODBUS. If the
current module ID deviates from the just configured module ID of the stored configu-
ration of the ricos FLEX BC MODBUS after a system start-up, the ricos FLEX BC MOD-
BUS does not go into RUN and shows the error on its web server.
'Delete configuration of all modules'
o
With [Delete] the configuration in the ricos FLEX BC MODBUS may be deleted.
Deployment

43