Table of Contents
Advertisement
For mounting, turn the locking lever of the module to be mounted upwards.
To mount the module put it to the gap between the both modules and push it, guided by the
stripes at both sides, to the mounting rail.
Turn the locking lever downward, again.
Plug again the electronic module, which you have removed before.
Wire your module.
Now you can bring your system back into operation.
Exchange of a module group
For demounting and exchange of a (head) module or a group of modules, due to mounting reasons
NOTICE
you always have to remove the electronic module right beside. After mounting it may be plugged
again.
Power-off your system.
Remove if exists the wiring of the module group.
Press the unlocking lever at the lower side of the just mounted right module near the module
group and pull it forward.
Turn all the locking lever of the module group to be exchanged upwards.
Pull the module group forward.
For mounting, turn all the locking lever of the module group to be mounted upwards.
To mount the module group put it to the gap between the both modules and push it, guided by
the stripes at both sides, to the mounting rail.
Turn all the locking lever downward, again.
Plug again the electronic module, which you have removed before.
Wire your module group.
Now you can bring your system back into operation.
Wieland Electric GmbH | BA001269 | 09/2021 (Rev. A)
Mounting, wiring and demounting
33
Advertisement
Table of Contents
