Table of Contents
Advertisement
Quick Start Guide
2
Attach the feet to the stand legs using eight of the size 10-24
screws. Note that each foot has two casters, only one of which
locks. Lock the casters to prevent the stand from rolling during
subsequent assembly.
3
Locate the box containing the printer head. It should already be open
with the underside of the printer facing up.
4
One of the stand legs has a connector in the center of the leg. (See
the following illustration.) Pull the connector from the access hole in
the leg and remove the tiewrap holding the connector in place.
Attach the connector to the receptacle on the bottom of the printer
head. Orient the stand legs so that the roll holder brackets are
facing the center of the printer head and align with the holes in the
bottom of the printer head. Attach both stand legs to the printer head
using eight of the size 10-24 screws. Note: To help ensure that the
legs seat properly on the printer head, attach screws snugly in
opposite corners first. Then, when all screws are in place, tighten
them securely.
CAUTION: Be careful not to pinch the cable when attaching the leg.
Stand leg
Attach connector from
stand leg to printer head
8
Foot
Advertisement
Table of Contents
