Table of Contents
Advertisement
6
When ink is visible in the ink primer sight tube (should take 5-10
seconds), close the ink delivery lines by pushing valve up and
remove the cartridge needle from the ink primer.
7
Insert the cartridge needle into the hole in the top of the ink
cartridge. Be sure the needle is tightly connected by turning the
fitting clockwise until finger-tight.
8
Gently tighten the fitting (about 1/4 turn) to prevent air leaks. Do not
overtighten. Open the ink delivery lines by pushing the valve down.
9
Wait 20 seconds for the ink pressure to stabilize. Remove the
cartridge from the carriage and remove the blue tape from the jet
ar ea of t he car t r i dge.
higher than a 30 degree angle. This could cause the cartridge
to lose pressure.
Check for ink on the jet plate. Continuous bleeding of the jet plate
indicates a loss of vacuum in the cartridge or an air leak in the lines.
A small amount of ink can be cleaned off the jet plate by dabbing
with a moist, lint-free cloth.
CAUTION! Do not tilt the cartridge up
Quick Start Guide
25
Advertisement
Table of Contents
