Table of Contents
Advertisement
3
Insert the media's leading edge into the back of the printer, aligning
the paper edge with the alignment mark on the platen. Continue
pushing the paper up into the printer. After a few seconds, the
printer will sense the presence of the media and feed it
automatically.
Media presence
sensor
Takeup roll
Note: Be sure that a media core is installed on the takeup roll.
Attach the leading edge of the media to the takeup roll with three
pieces of tape: one at the left, right, and center of the core. Orient
the media as shown in the preceding illustration.
As printing progresses, make sure the media feeds between the
dryer and the platen as shown in the preceding illustration.
As printing progresses, media loops down in front of the takeup
core and will be detected by the sensor on the printer stand leg.
The takeup roll will then be activated to roll the media.
Be sure not to block the sensor!
4
Adjust the media edge guides on the back of the printer. 1/16" gap
spacing is optimum.
Left side view
Feed
roll
Loading roll media
Quick Start Guide
Dryer
Media sensors for
feed and takeup
15
Advertisement
Table of Contents
