Interrupting A Programme And Changing The Options; Cancelling A Programme; Opening The Door - Zanussi ZWF 0147BX User Manual

STARTING A PROGRAMME WITHOUT THE
FINISH AT OPTION
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks, the
indicator
• The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE
FINISH AT OPTION
Check if the appliance has the correct hour set.
See in "Clock setting" how to set the appliances's
clock.
First set the programme (and add options) then set
the option .
1. Touch the button
time. With the first touch the time is rounded to
the nearest hour or to the nearest half an hour.
By each next touch the end time increases by
30 minutes segments until maximum range of
1)
20 hours.
The display shows the finish hour you set (e.g.
) and the indicator
this option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically and the
actual programme duration counts down in
minutes until the cycle end.
You can cancel or change the set of
the option
button . After touching the button
you can only cancel the option
To cancel the Finish At
1) If you keep the button
.
stops to
is on.
to set the desired end
is on to show that
:
before you touch the
option:
pressed the digits change in a quicker way.
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
the indicator
Touch the button
programme immediately.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch
The indicator of this button flashes.
2. Change the options.
If you change any option the
will be disabled.
3. Touch
The programme continues.

CANCELLING A PROGRAMME

1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.

OPENING THE DOOR

While a programme (or the
appliance door is locked. The indicator
CAUTION! If the temperature and
level of the water in the drum are too
high, you cannot open the door.
To open the door during the first minutes of
the cycle (or when the
.
1. Touch the button
2. Wait until the indicator
3. You can open the door.
to set the appliance
again and again until
goes off from the display.
again to start the
.
option (if set)
again.
for some seconds to
) operates, the
operates) :
to pause the appliance.
goes off.
is on.
13