Battery Replacement - Prestige APS-45HJ Owner's Manual

Transmitters Included With This Kit:
The transmitters are programmable and at times it may become necessary to replace
transmitters if they become broken or if they are stolen. If this is the case, order replace-
ment transmitters from Audiovox Customer Service @ 1-800-645-4994. The transmitters
packaged with this kit are 91PM
To Program new or replacement transmitters:
1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet/override/program push button switch 3 times.
3. The dash LED will flash one time and the siren will "chirp" 1 time indicating the
system is ready to accept programming for channel 1 Lock/Arm
and Panic.
4. Press and hold the lock button of the first transmitter until the parking lights
flash and a long chirp is heard from the siren
Repeat for each transmitter to be programmed. Note a maximum of 4 transmitters can be
programmed.
Turn the ignition switch off or allow 15 seconds of inactivity to exit the transmitter
program mode.
By completing the above, both buttons of the transmitters are programmed into their
default location.
Lock Button = Lock/Arm, Panic On & Off
Unlock Button = Unlock/Disarm, Panic On & Off
Trunk Button = Trunk Release, Panic Cancel. Press & Hold 2.5 seconds to
release trunk, Press while Panic Sounding to cancel panic
immediately.
Option Button = Use for an additional external function or a second vehicle
similarly equipped with an Audiovox Alarm

BATTERY REPLACEMENT

The transmitter incorporates a small LED visible through the case which is used to
indicate battery condition. You will notice a decrease in transmitter range as the battery
condition deteriorates. Transmitter battery replacement is recommended at least every 10
to 12 months, depending upon how frequently the transmitter is used.
91PM Uses Two CR2016 Lithium Battery
To replace the battery in the 91PM Transmitter
1) Remove the 3 #0 Pt. Philips Head Screws in the back of the case shown.
2) Remove the rear cover to access the discharged
batteries paying attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the
discharged batteries.
4) Insert the new batteries, than carefully snap closed the
transmitter case.
5) If you accidently dislodge the circuit board from the
transmitter housing, be certain that the
rubber membrane is seated properly, and the buttons are
properly exposed from the front
view of the case, then insert the circuit board, and return to
step #4.
Page 14
128-8819
14 of 16