Specifications; Troubleshooting - Sharp IG-CL15B Operation Manual

SPECIFICATIONS

Model
Power supply
Fan Speed Adjustment
Power consumption(W)
Airflow volume(m 3 /hour)
Applicable floor area(m 2 ) *1
Ion density(ions/cm 3 ) *2
Cord Length(m)
Outer dimensions(mm)
Weight(kg)
*1 The applicable floor area for which an emitted airborne ion density of about 25,000 ions/cm
sured at a point near the center of the room (at a height of about 1.2m from the floor), during operation at
the HIGH mode when the main unit is placed near a wall.
*2 Ion count per cm
floor) during operation at each airstream setting when the main unit is placed near the wall.
• The number of ions will vary according to the room conditions and operation mode.
Standby Power

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be a unit malfunctions.
The Plasmacluster Ion Generator dose not work.
Flashing
(red)
Flashing
(orange)
Lighting
(orange)
Flashing
(red)
Flashing
(orange)
OM-IG-CL15B_(EN+TH).indb Sec1:8 OM-IG-CL15B_(EN+TH).indb Sec1:8
blown into air at around the center of the room ( at a height of about 1.2m from the
3
In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this
product consumes about 0.9W of standby power.
For energy conservation, unplug the power cord when the unit is not in use.
Problem
Flashing
(blue)
Flashing
(blue)
IG-CL15B
220V , 50Hz
HIGH
24
78
15
25,000
2.0
265(W)x155(D)x330(H)
3.1
WHAT TO DO
• Make sure to put in the plug.
• Attach a filter properly.
• It's time to replace Plasmacluster Ion Generating
Unit.
Replace with a new Plasmacluster Ion
Generating Unit. (See page E-7)
• Plasmacluster Ions are not released. Dust may block the
filter, clean the filter. (See page E-5)
• Remove dust of the needle electrode. (See page E-6)
If the lights are still flashing after cleaning filter, unplug and
contact the store you purchased or Sharp service center.
• Filter is getting dirty. Clean the filter.
After cleaning the filter, press RESET Button for
3 seconds. (See page E-5)
• Confirm the Plasmacluster Ion Generating Unit is
set correct position. (See page E-7)
• Failure
Unplug the power cord and contact the store you
purchased or Sharp service center.
E-8
LOW
15
50
7,000
3 can be mea-
8/24/11 9:53:14 AM 8/24/11 9:53:14 AM