Installing The Scanner Software - Epson Expression 636 Easy Setup Manual

Caution:
Make sure that the scanner, the computer, and any other SCSI
devices are turned off and unplugged from the power source.
1. Install the SCSI board in your computer, if necessary. Follow
the instructions that came with your SCSI board.
2. Connect the 50-pin end of the cable to either the top or
bottom SCSI connector of the scanner; then squeeze the wire
clips together until they lock in place on both sides.
3. Plug the 25-pin connector into the SCSI port on your
computer. Tighten the two screws on the sides of the
connector.
4. Plug in the power cables of your computer, scanner, and
other external SCSI devices.
5. Turn on your scanner, then your computer. (Always turn the
scanner on before the computer.)
Note:
If you are using Windows 3.1, you need to install the SCSI software
included with your SCSI adapter. See your SCSI adapter documentation
for instructions.

Installing the Scanner Software

Now that you have connected the scanner to your computer, the
next thing to do is install your scanner software. Instructions for
installing all of the software included with your scanner are in
this section. You do not need to install all the software, but you
do need to install the EPSON Scanning Utilities.
6 Installing the Scanner Software