Introduction; Warning - Power Probe BASIC Instruction Manual

Power Probe Basic
Thank you for purchasing the Power Probe Basic. It's your best value for
testing automotive electrical problems.
After connecting it to the vehicle's battery you can now see if a circuit is
Positive, Negative or Open by probing it and observing the RED or GREEN
LED. You can quickly activate electric components with the press of the
power switch and YES, its short circuit protected. Continuity of switches,
relays, diodes, fuses and wires are easily tested by connecting them
between the auxiliary ground lead and the probe tip and observing the
GREEN LED. Check fuses and test for short circuits. Find faulty ground
connections instantly. The 20 ft. long lead will reach from bumper to
bumper and it has the option to connect a 20 foot extension lead to
make it reach up to 40 feet. Great for trucks, trailers and motorhomes.
If you are not using a Power Probe in your electrical testing, you are
wasting time.
Before using the Power Probe Basic, please read the instruction book
carefully.
When the Power Switch is depressed battery current is conducted
directly to the tip which may cause sparks when contacting ground or
certain circuits. Therefore the Power Probe should NOT be used around
flammables such as gasoline or its vapors. The spark of an energized
Power Probe could ignite these vapors. Use the same caution as you
would when using an arc welder.
The Power Probe Basic is NOT designed to be used with 110/220 AC-volt
house current, it is only for use with 6-12 VDC systems.

INTRODUCTION

www.powerprobe.com

WARNING!

• 800-655-3585
3