Connecting The Scanner To Your Macintosh - Epson ActionScanner ActionScanner II Getting Started

If the scanner comes on when you plug it in, turn it off by
pressing the
Warning:
Whenever you
before turning it back on. Rapidly turning it on and off can
damage the scanner.
Connecting the Scanner to Your
Macintosh
Follow the steps below to connect
SCSI port on your Macintosh using
with the scanner. This cable has a 25-pin connector on one end
and a 50-pin connector on the other. The SCSI ID is already set
to 2 and the SCSI terminator is on.
If you are already using the SCSI port on your computer for
another SCSI device, such as an external hard disk, you need a
SCSI cable with a 50-pin connector
connect the scanner to your other SCSI device and set the SCSI
ID and terminator as necessary; follow the instructions in
Chapter 1 of your scanner
OPERATE
button.
off the scanner, wait at least 10 seconds
turn
User's Guide.
the
scanner directly to the
the
SCSI cable included
on
both ends. You can then