Table of Contents
Advertisement
Chapter 4
• Enable VLAN
- Check this box and then you can change the VLAN ID of each SSID. If
you want to configure the Guest and Internal networks on VLAN, the switch you are
using must support VLAN. As a prerequisite step, configure a port on the switch for
handling VLAN tagged packets as described in the IEEE802.1Q standard, and enable
this field.
Note:
To apply any settings you have altered on the page, please click the Save button, and then you will be reminded to reboot
the device.
4. 3. 2.
Connect to Network (Repeater/Bridge)
1. Visit http://tplinkap.net, and log in with the username and password you set for the
access point.
2. Go to
Wireless
>
Connect to
3.
Repeater/Bridge
mode is supported here.
Repeater/Bridge Mode
• SSID (to be bridged)
extender wille be connecting to or click
• BSSID (to be bridged)
will be connecting to or click
• Security
- Select one of the security options to match with the host network.
•
No Security
•
WPA-PSK
- This option supports implementation of the WPA (Wi-Fi Protected
Access) standard. It is recommended.
• Password
- You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length should
be between 8 and 64 characters; for ASCII, the length should be between 8 and 63 characters.
•
WPA2-PSK
- This option supports implementation of the WPA2 (Wi-Fi Protected
Access) standard. It is also recommended.
• Password
- You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length should
be between 8 and 64 characters; for ASCII, the length should be between 8 and 63 characters.
Network.
- Enter the case-sensitive SSID of the host network which the
- Enter the MAC Address of the host network which the extender
Wireless Scanner
- This option disables the wireless security.
Wireless Scanner
and select a Wi-Fi network.
and select a Wi-Fi nework.
Configure the Access Point
24
Advertisement
Table of Contents
