TP-Link WA801ND User Manual page 25

Chapter 4
• Channel Width - Determines the channel width to be used. It is unnecessary to change
the default value unless required.
• Enable SSID Broadcast
to broadcast its name (SSID) on the air. If it's allowed, when wireless clients survey the
local area for wireless networks to associate with, they will detect the SSID broadcast
by the device.
Note:
To apply any settings you have altered on the page, please click the
the device.
Client Mode
• SSID (to be bridged)
extender wille be connecting to or click
• MAC Address (to be bridged)
extender will be connecting to or click
• Security - Select one of the security options to match with the host network.
• No Security
• WPA-PSK - This option supports implementation of the WPA (Wi-Fi Protected
Access) standard. It is recommended.
• Password - You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length should
be between 8 and 64 characters; for ASCII, the length should be between 8 and 63 characters.
• WPA2-PSK - This option supports implementation of the WPA2 (Wi-Fi Protected
Access) standard. It is also recommended.
• Password - You can enter ASCII or Hexadecimal characters. For Hexadecimal, the length should
be between 8 and 64 characters; for ASCII, the length should be between 8 and 63 characters.
• WEP - This option is the most basic form of wireless security that can be used
if your client devices can only access wireless using WEP (Wireless Equivalent
Privacy).
• Index - Select which of the four keys will be used.
• Autentication Type
• WEP KeyFormat
• Password - Enter the matching WEP key information for your network.
- Select or deselect this check box to allow or deny the device
- Enter the case-sensitive SSID of the host network which the
- Enter the MAC Address of the host network which the
Wireless Scanner
- This option disables the wireless security.
- Select Shared Key or Open System authentication type.
- Select ASCII or Hexadecimal format.
Save button, and then you will be reminded to reboot
Wireless Scanner and select a Wi-Fi network.
and select a Wi-Fi nework.
Configure the Access Point
22