Operating Procedure; Antistatic Feature - Nikon SMZ460 Instructions Manual

Operating Procedure

1. Place the specimen on the stage plate.
2. Turn both diopter rings on the binocular tubes until the end surface
3. Looking into the eyepieces, adjust the interpupillary distance by
4. Set the zooming knob to its highest magnification.
5. Rotating the focus knobs, bring the specimen image into focus. If,
6. Rotate the zooming knob to its lowest magnification.
7. Rotate the right- and lefthand diopter rings one after the other to
8. Repeat the above processes from 4. to 7. to make sure of exact

Antistatic Feature

Models SMZ460, SMZ445 and
C-PSC Focusing stand are
made antistatic. They are very
useful in observing specimens
weak against static.
The M4 ground tap (depth:
6 mm) is at the rear of the
zooming body. The φ 4 mm
ground jack is at the rear of the
focusing stand. Ground the
microscope using them as
required.
16
of each ring coincides with the black engraved line.
moving the binocular tubes, so that both the circular viewfields are
brought into coincidence.
beforehand, the distance between the specimen and the bottom of
the microscope main body is made about 100 mm, focusing will be
facilitated.
bring the images into focus independently.
focusing, and, then the image will keep its sharpness all the time of
continuous magnification change by zooming.
Tapped screw hole
for grounding